Water Heater Repair Mesa AZ: Troubleshooting A Gas Water Heater

Author: | Posted in Plumbing Contractors No comments

Water heaters are among the many appliances that homeowners don’t think about until there is a problem. After a prolonged time of using your water heater with no proper maintenance, chances are that the system will exhibit problems. Whether it is a leaking water heater, a break down, or if the system is making noise, it is essential to attend to the problem before it becomes worse. There are problems that you can fix without hiring a contractor for Water Heater Repair Mesa AZ. Below are some of the signs and symptom that show your system has a problem:

 

• Rust colored water or Smelling water
• Inadequate or no hot water
• Rumbling noises

 

How to troubleshoot a water heater

 

With a troubleshooting guide, you can save a substantial amount of money on making repairs. In this article, you’re going to learn how to solve some of the common problems of gas water heating systems.

 

Inadequate or no hot water is produced

 

The possible causes of this problem may include faulty control valve, faulty pilot or a faulty thermocouple. The problem may also be because your unit is undersized to meet your household needs or a damaged dip tube that is allowing cold and hot water to mix. After making certain that your system is facing any of the above problems, check the pilot operation and its flame and ensure that the thermocouple and control valves are in a proper condition. It is also important to check your plumbing system to ensure that no plumbing system has crossed over cold and hot water connections.

 

Rust colored water or smelling water

 

If your system is producing rust colored water, the possible causes are rusting in glass lined tank or ineffective sacrificial anode rod. You will need to replace the sacrificial rod with a magnesium rod to resolve the problem. Bacteria in your system would be the cause for smelling water. Flush the water in your tank and use hydrogen peroxide to clean the water

 

Another common problem that you can easily solve is rumbling of your system. This is due to buildup of sentiment at the bottom of the tank leading to overheating. You can get rid of the sediment through flashing the water in the tank. If the problems are difficult for you to handle, don’t hesitate to get Water Heater Repair Service in Mesa AZ.

Share

    Add Your Comment

    Enter Captcha Code *

    Pin It on Pinterest

    Shares
    Share This